Help

How to

Fit, care and magnet installation for every STRATUS piece.

Wear it

Wearing it with a helmet

Tie the helmet strap under the outer layer, so the mask can move over it.

Balaclavas · Fall/Winter 26

  1. Put on your balaclava.

  2. Put on your helmet.

  3. Adjust the mask layer over your nose, then run your helmet strap under the outer layer of the mask.

  4. Make sure the nose piece seals tight against your nose.

  5. SureFit: bring your goggles down over your eyes and the nose piece.
    Magnetic: bring your goggles down first, then attach the nose piece to them with the magnet.

Care

Hand wash, lay flat

Every piece

Hand wash in cold water with a mild, natural detergent. Lay flat to dry.

Magnetic pieces

Never machine wash. The magnet can tear out of the fabric and damage your machine.

Magnet install

Fit the magnet to your goggles

For the Archive magnetic balaclavas, the face mask and the goggle kit. Allow 24 hours before use.

  1. 01

    Clean your goggles

    Wipe the nose bridge with a microfibre cloth and isopropyl alcohol. Let it dry completely.

  2. 02

    Apply the adhesive

    Roll about 1/8” of the Sugru (included) between your fingers for 30 seconds, then mould it to the outer edge of the nose bridge.

  3. 03

    Place the magnet

    Press the magnet (included) firmly into the centre of the Sugru.

  4. 04

    Wait 24 hours

    Let it set, then say goodbye to fog. Leave at least 4–5 mm of space on the nose bridge for the best hold.

New goggles?

The Magnet Goggle Attachment Kit is $8: two magnets and one pack of Sugru.

Shop the kit →